Troubleshooting
Problem
The DVD player does not start playback.
Cannot activate some features, such as Angles, Subtitles, or
There is no sound from the centre and surround speakers.
Radio reception is poor.
The remote control does not function properly.
The timer is not working.
The display panel is dark.
Low hum or buzz sound.
Solution
–Insert a readable disc with the playback side facing down.
–Check the disc type, colour system and region code.
–Check for any scratches or smudges on the disc.
–Press SYSTEM SETUP to turn off the setup menu screen.
–Change the rating level.
–Moisture has condensed inside the system. Remove the disc and leave the system turned on for about an hour.
–The features may not be available on the DVD.
–Changing the language for the sound or subtitle is prohibited on the DVD.
–Make sure the centre and surround speakers are connected correctly.
–Press SURROUND button to select a correct surround sound setting.
–Make sure the source you are playing is recorded or broadcast in surround sound (DTS, Dolby Digital, etc.).
–If the signal is too weak, adjust the antenna or connect an external antenna for better reception.
–Increase the distance between the system and your TV or VCR.
–Tune in to the correct frequency.
–Place the antenna farther away from any equipment that may be causing the noise.
–Select the source (DISC or TUNER, for
example) before pressing the function button (ÉÅ, S , T).
–Reduce the distance between the remote control and the system.
–Replace the batteries with new ones.
–Point the remote control directly toward the IR sensor.
–Check that the batteries are loaded correctly.
–Set the clock correctly.
–Press and hold CLOCK•TIMER to switch on the timer.
–Press DIM again.
–Place the DVD system as far away as possible from electrical devices that may be causing interference.
E n g l i s h
47
