Philips SCD489 manual Sound alert on/of, Setting room temperature range, Temperature alert on/off

English 13

Sound alert on/of

If the sound alert is switched on, the parent unit beeps as soon as the fifth sound level light starts to burn orange while the volume is switched off..

1Select Xby pressing the – and + buttons and confirm by pressing the OK button.

2Select Cor Vand confirm by pressing the OK button.

Setting room temperature range

You can set the temperature range (minimum and maximum temperature) for your baby’s room.

1Select B– – ° by pressing the – and + buttons and confirm by pressing the OK button.

,Nappears on the display.

2Confirm by pressing the OK button.

3Set the desired minimum temperature by pressing the – and + buttons and confirm by pressing the OK button.

4Set the desired maximum temperature by pressing the – and + buttons and confirm by pressing the OK button.

Note: When the maximum temperature selected is lower than the room temperature, the unit consumes more power because the display will be on continuously.This is also the case when the minimum temperature set is higher than the room temperature.

Temperature alert on/off

If the temperature alert is switched on, the parent unit beeps if the actual room temperature exceeds the set maximum temperature or drops below the set minimum temperature. If no temperature has been set, the temperature alert will go off when the room temperature drops below 7°C or rises above 33°C.

1Select B– – ° by pressing the – and + buttons and confirm by pressing the OK button.

2Select Mby pressing the – and + buttons and confirm by pressing the OK button.

3Select Cor Vand confirm by pressing the OK button.

Cleaning and maintenance

Do not immerse the parent unit and the baby unit in water and do not clean them under the tap.

Do not use liquid cleaners or aerosol cleaners.

1Unplug the baby unit, if it is connected to the mains, and take the parent unit out of the charger.

2Clean the parent unit and the baby unit with a damp cloth.

Make sure the parent unit is dry before you place it back in the charger.

3Clean the charger with a dry cloth.