Philips SCD489 manual QuestionAnswer

English 15

QuestionAnswer

Why does the parent unit beep?

Why does the appliance produce a high-pitched noise?

Why don’t I hear a sound/ Why can’t I hear my baby cry?

Why does the parent unit react too quickly to other sounds?

Why does the parent unit react to baby’s crying slowly?

Why do the batteries of the baby unit run low quickly?

If the parent unit beeps while the LINK light blinks red and the message ( O) is shown on the display, the connection with the baby unit is lost. Move the parent unit closer to the baby unit.

If the parent unit beeps, the LINK light blinks red and the battery symbol on the display is empty, the batteries are running low. Recharge the batteries.

If you have switched off the volume while the sound alert is on, the parent unit beeps whenever the fifth sound level light starts to burn orange because the baby unit has picked up a sound.

If you have set the room temperature on the parent unit and the temperature alert is on, the parent unit beeps when the temperature drops below the set level or below 7 °C or when the temperature rises above the set level or above 33 °C.

The units may be too close to each other. Make sure the parent unit and the baby unit are at least 1 metre/3 feet away from each other.

The volume of the parent unit may be set too high. Decrease the volume of the parent unit.

The volume of the parent unit may be set too low or may be switched off. Increase the volume of the parent unit.

The microphone sensitivity level may be set too. Set the microphone sensitivity level to a higher level on the parent unit.

The baby unit and the parent unit may be out of range of each other. Reduce the distance between the units.

The baby unit also picks up other sounds than those of your baby. Move the baby unit closer to the baby (but observe the minimum distance of 1 metre/3 feet).

The microphone sensitivity level may be set too high. Decrease the microphone sensitivity level on the parent unit.

The microphone sensitivity level on the parent unit may be set too low. Increase the microphone sensitivity level on the parent unit.

The microphone sensitivity level may be set too high, which causes the baby unit to transmit more often. Decrease the microphone sensitivity level on the parent unit.

The volume on the baby unit may be set too high, which causes the baby unit to consume a lot of energy. Decrease the volume on the baby unit.