Philips SCD489 manual Parent unit Mains operation, Using the appliance

English

2Remove the lid.

3Insert four 1.5V AA batteries. (Fig. 4)

,Place two batteries on top of each other and make sure the + and – poles of the batteries point in the right direction.

4Put the battery compartment lid back onto the unit and turn it to the right (CLOSE ™) with the palm of your hand to close it. (Fig. 5)

Note: When the batteries are running low, the LINK light on the baby unit blinks.

Parent unit

Mains operation

1Put the adapter of the charger in the wall socket and place the parent unit in the charger. (Fig. 6)

,The POWER light goes on.

Battery operation

The parent unit runs on two rechargeable 1.2-volt AAA NiMh batteries that are supplied with the appliance.

Make sure your hands and the unit are dry when you insert the batteries.

1Slide the battery compartment lid downwards to remove it. (Fig. 7)

2Insert the two rechargeable batteries. (Fig. 8)

,Make sure the + and – poles of the batteries point in the right direction.

3Slide the battery compartment lid back onto the back of the parent unit until it locks into position (‘click’). (Fig. 9)

4Put the adapter in a wall socket and place the parent unit in the charger. (Fig. 6)

,The POWER light goes on.

5Leave the parent unit in the charger until the batteries are fully charged

,Charging takes at least 16 hours.

,Charging takes longer than 16 hours when the parent unit is switched on while charging.To shorten the charging time, switch off the parent unit.

,The POWER light stays on, even when the batteries are fully charged.

,When the batteries are fully charged, the parent unit can be used cordlessly for at least 8 hours.

Note: The operating time of 8 hours is based on the assumption that the baby unit will be transmitting 25% of the time and is in standby mode for the rest of the time (when the baby does not make

any sound).

Note: When the parent unit batteries are charged for the first time, the operating time will be less than 8 hours.The batteries only reach their full capacity after you have charged and discharged them four times.

Note: When the battery symbol on the display is empty, the LINK light blinks and the parent unit beeps, the batteries are running low. Place the parent unit in the charger.

Note: When the parent unit is not in the charger, the batteries gradually discharge, even when the parent unit is switched off.

Using the appliance

1 Place the parent unit and the baby unit in the same room to test the connection. (Fig. 10)