Philips SCD489 manual Storage, Environment, Guarantee and service, Frequently asked questions

14English

Storage

,When you are not going to use the baby monitor for some time, remove the batteries and store the parent unit, the baby unit, the adapter of the baby unit and the charger in the travel bag supplied.

,You can also use the travel bag to store the baby monitor while you travel.

Environment

,Do not throw away the appliance with the normal household waste at the end of its life, but hand it in at an official collection point for recycling. By doing this, you help to preserve the environment. (Fig. 35)

,Batteries contain substances that may pollute the environment. Do not throw empty batteries away with the normal household waste, but hand them in at an official collection point.Always remove the batteries before discarding the appliance or handing it in at an official collection point.

Guarantee and service

If you need information or if you have a problem, please visit the Philips website at www.philips.com

or contact the Philips Customer Care Centre in your country (you find its phone number in the worldwide guarantee leaflet). If there is no Customer Care Centre in your country, turn to your

local Philips dealer or contact the Service Department of Philips Domestic appliances and Personal Care BV.

Frequently asked questions

This chapter lists the questions most frequently asked about the appliance. If you cannot find the

answer to your question, contact the Customer Care Centre in your country.

Question	Answer
Why do the LINK lights	Place the parent unit in the charger and put the adapter of the
not blink and do the	charger in a wall socket.Then press the on/off button to check if the
displays not light up when	parent unit works. Also check if the baby unit works by pressing the
I press the on/off button	on/off button. If it does not work, replace the batteries.Then try to
of the baby unit and the	establish connection between the parent unit and baby unit. If the
parent unit?	LINK lights are still not on, move the parent unit closer to the baby
	unit, but not closer than 1 metre/3 feet. If it is still not possible to
	establish a connection, use the reset function to reset the units to
	their default settings.
Why does the LINK light	The parent unit and the baby unit may be out of range of each other.
on the parent unit blink	Move the parent unit closer to the baby unit.
and why does the unit
beep at the same time?
Why does the LINK light	The baby unit and the parent unit are out of range of each other.
on the baby unit blink red	Move the parent unit closer to the baby unit.
and why is the message
( O) shown
on the display?
Why does the LINK light	If the message ( O) is not shown on the display, the
on the baby unit blink	batteries of the baby unit are running low. Replace the batteries.
red?