Philips SCD489 manual Operating range, Dry materials Material thickness Loss of range, Features

English

Make sure the the baby unit is at least 1 metre/3 feet away from the parent unit.

2

,

,

,

3

,

,

,

,

4

5

Press and hold the on/off 3button on the baby unit for 2 seconds. (Fig. 11) The nightlight lights up briefly.

The display lights up and indicates the current room temperature.

Oappears on the display and the connection light starts to blink red while the baby unit tries to establish connection with the parent unit.

Press and hold the on/off button 3on the parent unit for 2 seconds. (Fig. 12) The sound level lights burn orange briefly.

The display lights up and the battery symbol and the temperature indication appear on the display.

The LINK light burns red briefly and then starts to blink green while the parent unit tries to establish connection with the baby unit.

The LINK light on the parent unit blinks green and the LINK light on the baby unit blinks red until connection has been established.This will take up to 30 seconds. Both LINK lights then burn green continously and the message Odisappears from the baby

unit’s display. (Fig. 13)

Place the baby unit at least 1 metre/3 feet away from your baby. (Fig. 14)

Position the parent unit within the operating range of the baby unit. Make sure it is at least 1 metre/3 feet away from the baby unit. (Fig. 15)

For more information on the operating range, see section ‘Operating range’ below.

Operating range

The operating range of the baby monitor is 300 metres/900 feet in open air. Depending on the surroundings and other disturbing factors, this range may be smaller. Indoors the operating range is up to 50 metres/150 feet.

Dry materials	Material thickness	Loss of range
Wood, plaster, cardboard, glass	< 30cm/12in	0-10%
(without metal, wires or lead)
Brick, plywood	< 30cm/12in	5-35%
Reinforced concrete	< 30cm/12in	30-100%
Metal grilles or bars	< 1cm /0.4in	90-100%
Metal or aluminium sheets	< 1cm/0.4in	100%

For wet and moist materials, the range loss may be up to 100%.

Features

Adjusting loudspeaker volume

1Briefly press the volume + and – buttons on the baby unit until the desired loudspeaker volume for the baby unit has been reached. (Fig. 16)

2Briefly press the volume + and – buttons on the parent unit until the desired loudspeaker volume for the parent unit has been reached. (Fig. 17)

,The displays give visual feedback on the volume settings of the units:

-A: parent unit volume switched off / monitoring baby silently;

-P: minimum volume (parent unit and baby unit);

-}: maximum volume (parent unit and baby unit).

Note: If you press the volume + and – buttons too long, the volume will not be adjusted.