Philips SCD489 manual English, Preparing for use, Baby unit, Mains operation, Battery operation

English

8IRoom temperature below temperature set in menu

9O‘No connection between units’ message

10{‘Volume level’ message

11SMessage when lullaby is interrupted D Travel bag

Important

Read these instructions for use carefully before you use the appliance and save them for future reference.

,This baby monitor is intended as an aid. It is not a substitute for responsible and proper adult supervision and should not be used as such.

,Check if the voltage that is indicated on the adapter corresponds to the local mains voltage before you connect the appliance.

,Use and store the appliance at a temperature between 10°C and 40°C.

,The appliance is suitable for mains voltages ranging from 220 to 240V.

,Do not expose the baby monitor to extreme cold or heat or to direct sunlight.

,Make sure the baby unit and the cord are always out of reach of the baby (at least 1 metre/3 feet away).

,Never place the baby unit inside the baby’s bed or playpen.

,Never cover the baby monitor with a towel or blanket.

,Never immerse any part of the baby monitor in water or any other liquid.

,Never use the baby monitor in moist places or close to water.

,Except for the battery compartments, do not open the housing of the baby unit and parent unit in order to prevent electric shock.

,Only use the adapter supplied to connect the baby unit to the mains.

,Only use the charger supplied to charge the parent unit.

,The adapters contain a transformer. Do not cut off the adapters to replace them with other plugs, as this will cause a hazardous situation.

,If the adapter of the baby unit is damaged, always have it replaced by one of the original type in order to avoid a hazard.

,If the charger or the adapter of the charger is damaged, always have the charger replaced by one of the original type in order to avoid a hazard.

,Always place batteries of the correct type in the baby monitor to avoid the risk of explosion. Always use rechargeable batteries of the correct type for the parent unit.

,Since continuous transmission is prohibited, you only hear your baby when it makes sounds.

Preparing for use

Baby unit

You can use the baby unit from the mains or on batteries. Even if you are going to use the unit from the mains, we advise you to insert batteries.This guarantees automatic back-up in case of mains failure.

Mains operation

1Put the small plug in the baby unit and put the adapter in a wall socket. (Fig. 2)

Battery operation

The baby unit runs on four 1.5-volt R6 AA batteries (not included). We strongly advise you to use Philips LR6 PowerLife batteries.

Make sure your hands and the unit are dry when you insert the batteries.

1 Turn the battery compartment to the left ( ¡ OPEN) with the palm of your hand. (Fig. 3)