42 Connecting the Controller
If you are using a Cable Box or DSS Receiver, connect the Controller to your VCR. The Controller will automatically select channels at the Cable Box or DSS Receiver during a timer recording. Leave your Cable Box or DSS Receiver turned on during a timer recording.
1
Connect the Cable Box or DSS Receiver to the VCR as shown below. For more information, please read page eight. Or, refer to the owner’s manual of your Cable Box or DSS Receiver.
Connect the Cable signal
to the IN Jack of the Cable Box or DSS Receiver.
Cable Box or DSS Receiver
Controller
CABLE |
|
|
|
BOX IN | OUT ANT.IN |
|
|
| R |
|
|
AUDIO |
|
|
|
| L |
|
|
CH3 CH4 | RF OUT | CABLE |
|
VIDEO |
|
|
|
|
| BOX | IN OUT |
|
|
| R |
|
| AUDIO |
|
Use an RF coaxial cable to |
|
| L |
connect the OUT Jack on the |
|
|
|
Cable Box or DSS Receiver to |
| VIDEO |
|
the ANT(enna) IN Jack on | CH3 CH4 |
| |
the back of the VCR. |
|
|
|
Connect the Controller to the CABLE BOX Jack on the back of the VCR.
ANT.IN
Use a second RF coaxial cable to
connect the RF OUT Jack on the VCR to the TV's ANTENNA IN
RF OUT Jack (as shown on page eight).
2
Connect the Controller to the CABLE BOX Jack on the back of the VCR as shown above.
3
Attach the Controller to the top of the VCR using adhesive tape. Make sure the Controller’s transmitter (the light on the top of the Controller) is pointed toward the Cable Box or DSS Receiver’s remote sensor.
Cable Box or DSS Receiver
Controller
|
|
|
|
|
|
|
| PLAY |
|
|
|
|
|
|
| REW | FF |
POWER | PAUSE |
|
|
|
|
|
| STOP/EJECT |
|
| VCR/TV |
|
|
|
| CHANNEL |
|
| VIDEO L AUDIO R | OTR | SP AM |
|
| ST | REC | REC/OTR |
| VCR | SLP |
|
| SAP | PLAY |
| |
HQ |
|
| TIMER PM | H | M | S M | PAUSE |
|
4
If you are using a Cable Box, follow the steps on pages 43 - 44 to make the Controller change channels at the Cable Box during timer recordings.
If you are using a DSS Receiver, follow the steps on pages 45 - 46 to make the Controller change channels at the DSS Receiver during timer recordings.
