Philips VCR 462 warranty Press the Menu button. Wait for a few seconds

44 Setting the Controller to Operate a Cable Box (cont’d)

7

Use the Number buttons to enter the two-digit code for your Cable Box. (See list below.)

SELECT CODE NUMBER OF YOUR CABLE BOX 02

TO TEST PUSH MENU					CBL/DSS					VCR	TV
DID CABLE BOX CHANGE
TO CHANNEL 09?					EJECT				POWER		MUTE
1 YES 2 NO
TO END PUSH EXIT					VOL					F.ADV	CHANNEL
CABLE BOX/DSS RECEIVER CODES
							PAUSE/STILL
GENERAL INSTRUMENTS	01, 02, 03, 04, 05, 06, 07
HAMLIN	. . . . . . . . . . . . . . .21, 22									PLAY
JERROLD	.01, 02, 03, 04, 05, 06, 07				REW						FF
OAK	. . . . . . . . . . . .16, 17, 18
PANASONIC	. . . . . . . . . . . . . . .19, 20
PIONEER	. . . . . . . . . . . . . . .11, 12
. . . . . . . . . . . . . . . . .SCIENTIFIC ATLANTA				VCR PLUS+							LIGHT
TOCOM	. . . . . . . . . . . .23, 24, 25			/ENTER
										STOP
ZENITH	13, 14, 15
		11		EXIT/STATUS						MENU	CLEAR
.MAGNAVOX DSS Receiver	. . . . . . . . . . . . . . .42, 43
RCA DSS Receiver	40	9
SONY DSS Receiver	. . . . . . . . . . . . . . . . . .41					1				2	3
8					4					5	6
		10			7					8	9
Press the MENU button. Wait for a few seconds.			100							0	GO-TO
• If the Cable Box changes to channel 09, go to step 9.
• If the Cable Box doesn’t change to channel 09, press the
			REC/OTR					INDEX			MEMORY
								...
Number 2 button to select NO. Use the Number buttons to								...
							VAR. SLOW				TRACKING SKIP
enter a different code for your Cable Box. Press the MENU but-
ton. When the Cable Box changes to channel 09, go to step 9.				SPEED VCR/TV SLOW							SEARCH

8

7

9

Press the Number 1 button to select YES.

10

A zero will appear in the SELECT OUTPUT CH menu. Press one Number button (3 or 4) to complete the out- put channel of your Cable Box (channel 03 or 04).

•Press 0 if you connected the VIDEO/AUDIO OUT Jacks of the Cable Box to the VCR’s VIDEO/AUDIO IN Jacks. A/V CON- NECT A/V REAR ONLY will appear.

•If you make a mistake, press the CLEAR button, then enter the correct output channel.

SELECT OUTPUT CH

OF YOUR CABLE BOX

03

TO CONTINUE PUSH MENU

TO CORRECT PUSH CLEAR

TO END PUSH EXIT

11

Press the MENU button or the EXIT/STATUS button.

“CABLE BOX CONTROL IS ON” will appear for five seconds.

REMOTE LOCATOR

Helpful Hints

•If your Cable Box does not respond to any of the codes at step 8, the Controller will not change channels at the Cable Box during a timer recording. You must select the chan- nel to be recorded at the Cable Box before a timer recording begins. Leave the Cable Box on for the timer recording. See page eight for details. You may want to exchange your current Cable Box for one that can be controlled by the VCR’s Controller.

•The Controller can change channels at the Cable Box only during a timer recording.