Pioneer D1200SPL owner manual Connecting the Unit, To prevent damage and/or injury

Connecting the Unit

CAUTION

•Disconnect the negative (–) terminal of the bat- tery to avoid the risk of short-circuit and damage to the unit.

•Secure the wiring with cable clamps or adhesive tape. To protect the wiring, wrap adhesive tape around it where they lie against metal parts.

•Do not route wires where they will get hot, for example where the heater will blow over them. If the insulation heats up, it may become damaged, resulting in a short-circuit through the vehicle body.

•The amplifier increases the load on the battery and charging system. Make sure that the vehicle’s alternator and battery have sufficient capacity for this amplifier. The use of a heavy-duty battery, parallel connection of ordinary batteries or an energy storage capacitor is recommended.

•Make sure that wires will not interfere with mov- ing parts of the vehicle, such as the gearshift, handbrake or seat sliding mechanism.

•Do not shorten any wires. Otherwise the protec- tion circuit may fail to work when it should.

•Never feed power to other equipment by cutting the insulation of the power supply wire to tap from the wire. The current capacity of the wire will be exceeded, causing overheating.

•Never replace the fuse with one of greater value or rating than the original fuse. Use of an improp- er fuse could result in overheating and smoke and could cause damage to the product and injury including burns.

ENGLISH ESPAÑOL DEUTSCH

CAUTION

To prevent damage and/or injury

•Do not ground the speaker wire directly or con- nect a negative (–) lead wire for several speakers.

•This unit is for vehicles with a 12-volt battery and negative grounding. Before installing it in a recre- ational vehicle, truck or bus, check the battery voltage.

•If the car stereo is kept on for a long time while the engine is at rest or idling, the battery may go dead. Turn the car stereo off when the engine is at rest or idling.

•If the system remote control wire of the amplifier is connected to the power terminal through the ignition switch (12 V DC), the amplifier will always be on when the ignition is on— regardless of whether the car stereo is on or off. Because of this, the battery could go dead if the engine is at rest or idling.

•DO NOT connect a subwoofer with a lower impedance than specified in the “Connecting the Speaker Wires” section. Amplifier damage, smoke, and overheating could result from a non- specified connection. The amplifier surface could also become hot to the touch and minor burns could result.

•Connect either of three subwoofers to the amplifi-

er; 1: a subwoofer with a 500 W or larger nomi-

nal input and an impedance 4 Ω, 2: a subwoofer

with a 1 000 W or larger nominal input and an impedance 2 Ω or 3: a subwoofer with a 1 200 W or larger nominal input and an impedance 1 Ω. If the nominal input and impedance are out of the above ranges, the subwoofer may catch fire, emit smoke or become damaged.

•Install and route the separately sold battery wire as far away as possible from the speaker wires. Install and route the separately sold battery wire, ground wire, speaker wires and the amplifier as far away as possible from the antenna, antenna cable and tuner.

•Cords for this product and those for other prod- ucts may be different colors even if they have the same function. When connecting this product to another product, refer to the supplied manuals of both products and connect cords that have the same function.

FRANÇAIS ITALIANO NEDERLANDS êìëëäàâ

6