Adjusting initial settings
1
Initialsettings lets you per form initial setup of
differentsettings for this unit.
1Functiondisplay
Showsthe function status.
1 PressSOURCE and hold until the unit
turnsoff.
2 PressSOURCE and hold until FM ap-
pearsin the display.
3 PressAUDIO to display the function
names.
PressAUDIO repeatedly to switch between
thefollowing settings:
FM(FM tuning step)A-PI (Auto PI Seek)
SAVE(Power save)
Usethe following instructions to operate each
particularsetting.
#Tocancel initial settings, press BAND.
#Youcan also cancel initial settings by holding
downSOURCE until the unit turns off.
Setting the FM tuning step
Normallythe FM tuning step employed by
seektuning is 50kHz. When AFor TA is on,
thetuning step automatically changes to 100
kHz.It may be preferable to set the tuning step
to50 kHz when AFis on.
!Thetuning step remains at 50 kHz during
manualtuning.
1 PressAUDIO to select FM.
2 Presscor dto select the FM tuning
step.
Presscto select 50 (50 kHz). Press dto se-
lect100 (100 kHz).
Switching Auto PI Seek
Theunit can automatically search for a differ-
entstation with the same programming, even
duringpreset recall.
1 PressAUDIO to select A-PI.
2 Pressaor bto turn the Auto PI seek
onor off.
Saving the batteryconsumption
Itis possible to save the batter y consumption
whenthis unit is turned off. After one minute
ofturning off this unit, this unit will be
switchedinto power save mode.
!Youcannot insert and eject a disc while
thisunit is in power save mode.
!Youcan only use SOURCE while this unit is
inpower save mode.
Important
Whenyou disconnect a battery in order to replace
it,this mode is turned off. When installing this
unitin a vehicle that does not have an ACC (ac-
cessory)position on the ignition switch, the vehi-
clebattery may be drained depending on a
connectionmethod. After checking the connec-
tionmethod, turn this mode on if needed.
1 PressAUDIO to select SAVE.
2 Pressaor bto turn power save on or
off.
Initial Settings
En
24
Section
09