Pioneer DEH-P690UB Adjusting the brightness, Setting the rear output and subwoofer controller

	Section
Operating this unit	02

2Press MULTI-CONTROL to turn dimmer

on.

# To turn dimmer off, press MULTI-CONTROL again.

Adjusting the brightness

You can adjust the display brightness. Initially this mode is set to 12.

1Use MULTI-CONTROL to select Brightness.

2Push MULTI-CONTROL left or right to adjust the brightness level.

0to 15 is displayed as the level is increased or

decreased.

# When dimmer is functioning, the brightness level can be adjusted 0 to 10.

Setting the rear output and subwoofer controller

This unit’s rear output (rear speaker leads out- put and RCA rear output) can be used for full- range speaker (Rear SP :F.Range) or subwoo- fer (Rear SP :S/W) connection. If you switch the rear output setting to Rear SP :S/W, you can connect a rear speaker lead directly to a subwoofer without using an auxiliary amp. Initially, the unit is set for rear full-range speak- er connection (Rear SP :F.Range).

1Use MULTI-CONTROL to select S/W control.

Notes

!Even if you change this setting, there is no output unless you turn the subwoofer output on (refer to Using subwoofer output on page 27).

!If you change this setting, subwoofer output in the audio menu return to the factory set- tings.

!Both rear speaker leads outputs and RCA rear output are switched simultaneously in this setting.

Switching the sound muting/ attenuation

Sound from this system is muted or attenu- ated automatically when the signal from the equipment with mute function is received.

!The sound is muted or attenuated, MUTE or ATT are displayed and no audio adjust- ment is possible.

!Sound from this system returns to normal when the muting or attenuation is can- celed.

1Use MULTI-CONTROL to select Mute.

2Press MULTI-CONTROL to switch the tel- ephone muting/attenuation.

Pressing MULTI-CONTROL will switch be- tween TEL ATT (attenuation) and TEL mute (muting) and that status will be displayed.

Switching the feature demo

English

2Press MULTI-CONTROL to switch the rear output setting.

Pressing MULTI-CONTROL will switch be- tween Rear SP :F.Range (full-range speaker) and Rear SP :S/W (subwoofer) and that status

will be displayed.

# When no subwoofer is connected to the rear

output, select Rear SP :F.Range.

# When a subwoofer is connected to the rear output, set for subwoofer Rear SP :S/W.

The feature demo automatically starts when power to this unit is turned off while the igni- tion switch is set to ACC or ON.

1Use MULTI-CONTROL to select Demonstration.

2Press MULTI-CONTROL to turn the fea-

ture demo on.

# To turn the feature demo off, press MULTI-CONTROL again.

En 31