Pioneer DEH-P740MP Introduction of audio adjustments, Setting the sound focus equal- izer

07
Section
Audio Adjustments
En 31
English Español Deutsch Français Italiano Nederlands
Introduction of audio
adjustments
1AUDIOdisplay
Shows the audio adjustments status.
Press AUDIOto display the audio function
names.
Press AUDIO repeatedly to switch between the
following audio functions:
Fad (balance adjustment)—EQ(equalizer curve
adjustment)—Bass(bass)—Treble (treble)—
Loud(loudness)—Sub-W1 (subwoofer1)/Non Fad
(non fading output on/off)—Sub-W2
(subwoofer2)/Non Fad(non fading output set-
ting)—HPF (high pass filter)—SLA (source level
adjustment)
•When the subwoofer controller setting is only
S.W Control:EXT, you cannot switch the Sub-W1.
(Refer to page 38.)
•You can select the Sub-W2 only when
Subwoofer output is switched on in the Sub-W1.
• When the subwoofer controller setting is only
S.W Control:EXT, you can switch the non fading
output on/off mode. (Refer to page 38.)
•You can select the non fading output setting
mode only when non fading output is switched
on in the non fading output on/off mode.
•When selecting the FM tuner as the source,
you cannot switch to SLA.
•To return to the playback display, press
BAND/ESC.
Note
•If you do not operate the audio function within
about 30 seconds, the display is automatically
returned to the source display.
Setting the sound focus equal-
izer
Clarifying the sound image of vocals and instru-
ments allows the simple staging of a natural,
pleasant sound environment.
Even greater listening enjoyment will be
obtained if seating positions are chosen care-
fully.
•FRT1boosts the treble on the front output and
the bass on the rear output.
FRT2boosts the treble and the bass on the front
output and the bass on the rear output. (The
bass boost is the same for both front and rear.)
For both FRT1and FRT2 the Hsetting provides a
more pronounced effect than the Lsetting.
1 Press SFEQ to select the desired SFEQ
mode.
FRT1-H(front1-high) —FRT1-L (front1-low) —
FRT2-H(front2-high) —FRT2-L (front2-low) —
CUSTOM(custom) —SFEQ OFF (off)
2 Press 2or 3to select the desired position.
Press 2or 3until the desired position appears
in the display.
LEFT(left) —CENTER (center) —RIGHT (right)
Notes
•If you adjust the bass or treble, CUSTOM
memorizes an SFEQmode in which the bass
and treble are adjusted for personal prefer-
ence.
1