Audio Adjustments
Adjusting bass
You can adjust the cut-off frequency and the
bass level.
•In FRT1 mode, bass adjustment affects only
the rear output: front output cannot be
adjusted.
1 Press AUDIO to select Bass.
Press AUDIO until Bassappears in the display.
2 Select the desired frequency with 2/3.
Press 2or 3until the desired frequency
appears in the display.
40—63—100—160 (Hz)
3 Press 5or ∞to adjust the bass level.
Each press of 5or ∞increases or decreases
the bass level.+6––6 is displayed as the level is
increased or decreased.
Adjusting treble
You can adjust the cut-off frequency and the
Treble level.
•In FRT1 and FRT2 modes, treble adjustment
affects only the front output: rear output cannot
be adjusted.
1 Press AUDIO to select Treble.
Press AUDIO until Trebleappears in the display.
2 Select the desired frequency with 2/3.
Press 2or 3until the desired frequency
appears in the display.
2.5k—4k—6.3k—10k (Hz)
3 Press 5or ∞to adjust the treble level.
Each press of 5or ∞increases or decreases
the treble level.+6––6 is displayed as the level is
increased or decreased.
Adjusting loudness
Loudness compensates for deficiencies in the
low- and high-sound ranges at low volume.
1 Press AUDIO to select Loud.
Press AUDIO until Loudappears in the display.
2 Press 5to turn loudness on.
Loudness level (e.g., Loud Mid) appears in the
display.
3 Press 2or 3to select the level.
Press 2or 3until the desired level appears in
the display.
Low(low)—Mid (mid)—High (high)
4 Press ∞to turn loudness off.
Loud OFFappears in the display.
Using subwoofer output
This unit is equipped with a subwoofer output
which can be switched on or off.
1 Press AUDIO to select Sub-W1.
When the subwoofer controller setting is S.W
Control:EXT, you cannot select Sub-W1. Press
AUDIOuntil Sub-W1 appears in the display.
2 Press 5to turn subwoofer output on.
Sub-W1 Normalappears in the display.
Subwoofer output is now on.
•You can turn off subwoofer output by pressing
∞.
3 Press 2or 3to select the phase of sub-
woofer output.
Press 2to select reverse phase and Rev.
appears in the display. Press 3to select normal
phase and Normalappears in the display.
En
34
07
Section