Initial Settings
Switching the auxiliary setting
It is possible to use auxiliary equipment with
this unit. Activate the auxiliary setting when
using auxiliary equipment connected to this
unit.
1 Press FUNCTION to select AUX.
Press FUNCTION repeatedly until AUX appears
in the display.
2 Select AUXon or off with 5/∞.
Pressing 5/∞will switch AUXbetween on and
off and that status will be displayed (e.g.,
AUX :ON).
Switching the dimmer setting
To prevent the display from being too bright at
night, the display is automatically dimmed
when the car’s headlights are turned on. You
can switch dimmer on or off.
1 Press FUNCTION to select DIM.
Press FUNCTION repeatedly until Dimmer
appears in the display.
2 Select DIMon or off with 5/∞.
Pressing 5/∞will switch Dimmerbetween on
and off and that status will be displayed (e.g.,
Dimmer :ON).
Selecting the brightness
You can select the display brightness. Initially
this mode is set to 12.
1 Press FUNCTION to select BRIGHT.
Press FUNCTION repeatedly until Brightness
appears in the display.
2 Select the desired brightness with 2/3.
•The display shows 0– 15.
Setting the rear output and sub-woofer controller
This product’s rear output (rear speaker leads
output and RCA rear output) can be used for
full-range speaker (Rear SP:FULL) or subwoofer
(Rear SP:S.W) connection. If you switch rear
output setting to the Rear SP:S.W, you can con-
nect a rear speaker lead directly to a subwoofer
without using an auxiliary amp.
Initially, the unit is set for rear full-range speaker
connection (Rear SP:FULL).
When rear output are connected to full range
speakers (when Rear SP:FULL is selected), you
can connect the RCA subwoofer output to a
subwoofer. In this case, you can select whether
to use the subwoofer controller’s (low pass
filter, phase) built-in S.W Control:INTor the
auxiliary S.W Control:EXT.
En
38
08
Section