Pioneer DEH-P80RS Setting the high pass filter for front speakers, Audio Adjustments

Section

11 Audio Adjustments

!Even if the speaker unit (filter) is muted, you can adjust the muted speaker units (fil- ters). However, mute is automatically can- celed when the level is adjusted.

1Use MULTI-CONTROL to select F.HPF 1 (or R.HPF 1).

F.HPF 1 (or R.HPF 1) appears in the display.

2Push and hold MULTI-CONTROL down to mute the selected speaker unit (filter).

MUTE is displayed.

# To cancel the muting, push MULTI-CONTROL up.

Setting the high pass filter for front speakers

1Use MULTI-CONTROL to select F.HPF 1. F.HPF 1 appears in the display.

2Push MULTI-CONTROL left or right to select slope.

Each time MULTI-CONTROL is pushed left or right, slopes are selected in the following order:

–12— –6—Pass (0) (dB/oct.)

# If you set the slope to 0 dB/oct. (Pass), the audio signal bypasses the filter, so the filter does not have an effect.

3Turn MULTI-CONTROL to select F.HPF 2. F.HPF 2 appears in the display.

4Push MULTI-CONTROL left or right to select cut-off frequency.

Each time MULTI-CONTROL is pushed left or right, cut-off frequencies are selected in the following order:

50—63—80—100—125—160—200 (Hz) Only frequencies higher than those in the se- lected range are output from the front speak- ers.

5Push MULTI-CONTROL up or down to adjust the output level of the front speak- ers.

Each time MULTI-CONTROL is pushed up or down, the level of the front speakers increases or decreases. ±0 to –24 is displayed as the level is increased or decreased.

Setting the high pass filter for rear speakers

1Use MULTI-CONTROL to select R.HPF 1. R.HPF 1 appears in the display.

2Push MULTI-CONTROL left or right to select slope.

Each time MULTI-CONTROL is pushed left or right, slopes are selected in the following order:

–12— –6—Pass (0) (dB/oct.)

# If you set the slope to 0 dB/oct. (Pass), the audio signal bypasses the filter, so the filter does not have an effect.

3Turn MULTI-CONTROL to select R.HPF 2. R.HPF 2 appears in the display.

4Push MULTI-CONTROL left or right to select cut-off frequency.

Each time MULTI-CONTROL is pushed left or right, cut-off frequencies are selected in the following order:

50—63—80—100—125—160—200 (Hz) Only frequencies higher than those in the se- lected range are output from the rear speak- ers.

5Push MULTI-CONTROL up or down to adjust the output level of the rear speak- ers.

Each time MULTI-CONTROL is pushed up or down, the level of the rear speakers increases

or decreases. ±0 to –24 is displayed as the level is increased or decreased.

56 En