Pioneer DEH-P80RS About the demo mode, Use and care of the remote control, Reverse mode

Section

01 Before You Start

!After switching, reset the microprocessor.

WARNING

Do not use the unit in standard mode when a speaker system for 3-way network mode is con- nected to this unit. This may cause damage to the speakers.

%Use a thin standard tip screwdriver to switch the DSP switch on the side of this unit.

Reverse mode

If you do not perform an operation within about 30 seconds, screen indications start to reverse, and then continue reversing every 10 seconds. Pressing BAND when power to this unit is turned off while the ignition switch is set to ACC or ON cancels the reverse mode. Press BAND again to start the reverse mode.

!You can also perform the same operation from Switching the reverse mode on Initial Settings. For more details, see Switching the reverse mode on page 67.

Note

Even when the battery is disconnected or the mi- croprocessor is reset, this unit’s audio setting re- mains in the memory for at least one day. If you want to reset the audio setting, refer to Resetting the audio functions on page 66.

About the demo mode

This unit features two demonstration modes. One is the reverse mode, the other is the fea- ture demo mode.

Important

The red lead (ACC) of this unit should be con- nected to a terminal coupled with ignition switch on/off operations. If this is not done, the vehicle battery may be drained.

Feature demo mode

The feature demo automatically starts when power to this unit is turned off while the igni- tion switch is set to ACC or ON. Pressing DISPLAY during feature demo operation can- cels the feature demo mode. Press DISPLAY again to start the feature demo mode. Remem- ber that if the feature demo continues operat- ing when the car engine is turned off, it may drain battery power.

!You can also perform the same operation from Switching the feature demo on Initial

Settings. For more details, see Switching the feature demo on page 66.

Use and care of the remote control

Installing the battery

Slide the tray out on the back of the remote control and insert the battery with the plus (+) and minus (–) poles pointing in the proper di- rection.

!When using for the first time, pull out the film protruding from the tray.

8 En