Section
14 
Connection
Important
!This unit cannot be installed in a vehicle with- out ACC (accessory) position on the ignition switch.
F | ACC | ON | F | ON | ||||
| ||||||||
F |
|
|
|
| F |
|
|
|
O |
|
|
| S | O |
|
| S |
|
|
|
| T |
|
|
| T |
|
|
| R | A |
|
| R | A |
|
| T |
|
| T |
| ||
ACC position | No ACC position | |||||||
!Use of this unit in conditions other than the following could result in fire or malfunction.
—Vehicles with a
—Speakers with 45 W (output value) and 4 W (impedance value).
!To prevent a
—Disconnect the negative terminal of the battery before installation.
—Secure the wiring with cable clamps or ad- hesive tape. To protect the wiring, wrap ad- hesive tape around them where they lie against metal parts.
—Place all cables away from moving parts, such as gear shift and seat rails.
—Place all cables away from hot places, such as near the heater outlet.
—Do not pass the yellow cable through a hole into the engine compartment to con- nect to a battery.
—Cover any disconnected cable connectors with insulating tape.
—Do not shorten any cables.
—Never cut the insulation of the power cable of this unit in order to share the power with other devices. Current capacity of the cable is limited.
—Use a fuse of the rating prescribed.
—Never wire the speaker negative cable di- rectly to ground.
—Never band together multiple speaker’s ne-
gative cables.
!Control signal is output through blue/white cable when this unit is powered on. Connect it to an external power amp’s system remote control or the vehicle’s
!Never connect blue/white cable to external power amp’s power terminal. Also, never con- nect it to the power terminal of the auto anten- na. Otherwise, battery drain or malfunction may result.
!Black cable is ground. This cable and other product’s ground cable (especially,
Cord function may differ according to the pro- duct, even if cord color is the same. When con- necting this system, be sure to check all manuals and connect cords correctly.
42
En
