Pioneer DVR-433H-S, DVR-433H-K manual Rgb

13The Initial Setup menu

Setting	Options	Explanation
Component Video Out	Interlace •	Select if your monitor/TV is not compatible with progressive-scan
		video.
	Progressive	Select if your monitor/TV is progressive-scan compatible. Check the
		operating instructions that came with your monitor/TV if you’re not
		sure.

For Component Video Out to be effective, the AV1 Out setting (see below) must be set to something other than RGB.

AV1 Out	Video •	Sets the AV1(RGB)-TVSCART output to standard composite video
		(compatible with all TVs).
	S-Video	Sets the AV1(RGB)-TVSCART output to S-video. Recommended if you
		are using a long SCART cable.
	RGB	Sets the AV1(RGB)-TVSCART output to RGB. Good quality but check
		your TV for compatibility.

If you choose a setting that is incompatible with your TV you may not be able to see any picture at all. In this case either switch off and reconnect using the supplied video cable, or reset the recorder (see Resetting the recorder on page 111).

The Component Video Out setting (see above) has no effect when AV1 Out is set to RGB.

AV2/L1 In	Video •	Sets the AV2/AUTO START REC (INPUT 1/DECODER) SCART input to
		standard composite video.
	S-Video	Sets the AV2/AUTO START REC (INPUT 1/DECODER) SCART input to
		S-video.
	RGB	Sets the AV2/AUTO START REC (INPUT 1/DECODER) SCART input to
		RGB.
	Decoder	Use this setting if you connected a decoder to the AV2/AUTO START
		REC (INPUT 1/DECODER) SCART connector. For scrambled channels,
		make sure that the channel Decoder setting is set to On. (See Manual
		CH Setting on page 93.)
NTSC on PAL TV	On •	NTSC discs will play correctly on PAL-only TVs.
	Off	Use if your TV is already NTSC-compatible.

Many recent PAL TVs are compatible with NTSC input and so this setting can be switched off. Check the operating instructions that came with your TV. See also About NTSC on PAL TV on page 99 for related information.

Audio In Settings

Nicam Select	NICAM •	Record the NICAM audio in a NICAM broadcast.
	Regular Audio	Record the non-NICAM audio in a NICAM broadcast. (You can still
		switch the audio to record using the AUDIO (SHIFT + 1) button before
		recording.)
Tuner Level	Normal •	Standard setting.
	Compression	Use if the audio level from the built-in tuner is excessive, causing dis-
		tortion.
External Audio	Stereo •	Select if the audio from the currently selected external input is stan-
		dard stereo.
	Bilingual	Select if each channel carries a separate soundtrack.

When the external audio is from the DV input, an audio subcode channel within the DV audio tells the recorder whether the audio is stereo or bilingual. This has priority over the setting you make here.

94

En