Pioneer HD-V9000 manual Terminal button functions, Command mnemonics, Arguments

No. Argument	Mnemonics	Command Name
54	CS	Clear Screen
55	WW	Real Time Clock Set
56	arg CM	Communication Control
		Set
57	?P	Player Active Mode
		Request
58	?L	Player Model Number
		Request
59	?X	Player Model Name
		Request
60	?W	Real Time Clock Request
61	?M	CCR Mode Request
62	?N	Input Number Request
63	?E	Error Code Request
64	#I	Input Unit Request
65	$A	Register A Request
66	$D	Register D Request
67	?Z	Firmware Version Request
68	?O	System Property Request
69	?B	File List Request

Command mnemonics

Command mnemonics consist of two-digit ASCII alphabetic coded characters. Uppercase and lowercase characters can be used without distinction.

Arguments

(1)Arguments are placed in front of the command.

If a command requiring an argument has no argument, an error is generated.

(2)Arguments are of the following types:

1.Address:

The address consists of ASCII digit characters for the frame number and time code, according to the address mode.

The address mode is determined by the FR and TM commands.

If a value greater than the maximum value is attributed, the command will not work normally.

2.Argument:

The argument expresses a parameter for commands with arguments other than the address (KL, GP, DS, etc.).

The argument consists of ASCII alphabetic coded characters and digit characters.

Communications interface user’s manual

For detailed information on the serial interface commands, download the “HD-V9000 Communications Interface User’s Manual” from the Pioneer website.

Setting the extend 09

terminal button functions

“Extend Terminal” refers to the function for controlling this unit by turning the switch of a device connected to the EXT TERMINAL connector on the main unit’s rear panel on and off.

•SW1 to SW8 on the EXT TERMINAL connector on the main unit’s rear panel are pulled up to +3.3 V. Assign functions to combinations of SW1 to SW8.

•For the pin layout, see page 55.

•A maximum of 56 switches can be connected by combining SW1 to SW8.

•For the switch combinations and functions assigned upon purchase, see page 59.

1Display the SETUP screen. Press the SETUP button.

2Select Initial Settings  Options  Extend

Terminal  User.

Use the /// buttons to select, then press the ENTER button.

			Initial Settings
Currrent (1-30)		New
1.			PLAY	1	GROUP
			STOP
2.				2	GROUP 2
3.			PAUSE	3	GROUP 3
4.			STEP FWD	4	GROUP
5.	ENTER		STEP REV	5	GROUP
6.	GROUP 1		SCAN FWD	6	GROUP
7.	GROUP 2		SCAN REV	7	GROUP
8.	GROUP 3		SKIP FWD	8	GROUP

57

En