Pioneer KEH-P7020R 08Initial Settings, Adjusting initial settings, Setting the time

Section

08Initial Settings

Adjusting initial settings

1

Initial settings lets you perform initial set up of different settings for this unit.

1FUNCTION display

Shows the function status.

1Press SOURCE and hold until the unit turns off.

2Press FUNCTION and hold until time appears in the display.

3Press FUNCTION to select one of the initial settings.

Press FUNCTION repeatedly to switch between the following settings:

CLOCK—FM—DAB—A-PI—WARN—AUX—DIM—BRIGHT—ILL—SW—TEL1—TEL2 Use the following instructions to operate each particular setting.

•To cancel initial settings, press BAND/ESC.

•You can also cancel initial settings by holding down FUNCTION until the unit turns off.

Setting the time

This is used to set the time on the unit’s clock display.

1Press FUNCTION to select the CLOCK. Press FUNCTION until the time appears in the display.

2Select the portion of the time display you wish to set with 2/3.

Pressing 2/3 will select a portion of the clock display:

HOUR—MINUTE

As you select portions of the clock display the portion selected will blink.

3Select the correct time with 5/∞. Pressing 5 will increase the selected hour or minute. Pressing ∞ will decrease the selected hour or minute.

Setting the FM tuning step

Normally the FM tuning step employed by seek tuning is 50 kHz. When AF or TA is on the tuning step automatically changes to 100 kHz. It may be preferable to set the tuning step to 50 kHz when AF is on.

1 Press FUNCTION to select FM.

Press FUNCTION repeatedly until FM Step appears in the display.

2Select the FM tuning step with 2/3.

Pressing 2/3 will switch the FM tuning step between 50 kHz and 100 kHz while AF or TA is on. The selected FM tuning step will appear in the display.

Note

•The tuning step remains at 50 kHz during manual tuning.

36En