Section
07Audio Adjustments
Fine adjusting equalizer curve
You can adjust the center frequency and the Q factor (curve characteristics) of each currently selected curve band (EQ Low/EQ Mid/EQ High).
Adjusting bass
You can adjust the
•In FRT1 mode, bass adjustment affects only the rear output: front output cannot be adjusted.
Level (dB)
Q=2N
Q=2W
1 Press AUDIO to select Bass.
Press AUDIO until Bass appears in the display.
Center frequency 
Frequency (Hz)
1Press AUDIO and hold unitil frequency and the Q factor (e.g., F 80 Q 1W) appears in the display.
2Press AUDIO to select the desired band for adjustment.
LOW
3Select the desired frequency with 2/3. Press 2 or 3 until the desired frequency appears in the display.
LOW :
MID :
HIGH : 3.15
4Press 5/∞ to select the desired Q factor. Press 5 or ∞ until the desired Q factor appears in the display.
2
Note
•If you make adjustments when a curve other than CUSTOM2 is selected, CUSTOM1 curve is updated. 
2Select the desired frequency with 2/3. Press 2 or 3 until the desired frequency appears in the display.
3Press 5 or ∞ to adjust the bass level. Each press of 5 or ∞ increases or decreases the bass level.+6 – 
Adjusting treble
You can adjust the
•In FRT1 and FRT2 modes, treble adjustment affects only the front output: rear output cannot be adjusted.
1 Press AUDIO to select Treble.
Press AUDIO until Treble appears in the display.
2Select the desired frequency with 2/3. Press 2 or 3 until the desired frequency appears in the display.
3Press 5 or ∞ to adjust the treble level. Each press of 5 or ∞ increases or decreases the treble level.+6 – 
32En
