Preparation
How to route cables
Speed clamps and bead bands are included with this unit for bunching cables together. Once components are connected, follow the following steps to route cables.
* As viewed from the rear of the display.
06
English
1.Organize cables together using the provided speed clamps.
Insert ➀ into an appropriate hole on the rear of the unit, then snap ➁ into the back of ➀ to fix the clamp.
Speed clamps are designed to be difficult to undo once in place. Please attach carefully.
To attach the speed clamps to the main unit
Connect the speed clamps using the 6 holes marked with “o” below, depending on the situation.
2.Bunch separated cables together and secure them with the provided bead bands.
Do not allow excessive stress to be placed on the ends of cables.
NOTE
•Cables can be routed to the right or left.
* As viewed from the rear of the display.
To remove speed clamps
Using pliers, twist the clamp 90° and pull it outward.
In some cases the clamp may have deteriorated over time and may get damaged when removed.
19
En
