Pioneer PRS-D1100M owner manual Connection Diagram

Connection Diagram

•This diagram shows connections using external output. Slide the input switch to the left.

•In the case of connecting the external output from a car stereo to an RCA input, use the jack used for full- range output. This is because the LPF of the amplifier cannot be turned OFF. If this jack cannot be used, connect the subwoofer output jack to the RCA input.

•When you connect with speaker output, connections defers from the diagram. For details, see the “Using the Speaker Input” section. In either case, you need to set the input switch. For details, see the “Setting the Unit” section.

•Always use the special red battery and ground wire ([RD-223] and [RD-222]), which are sold separately. Connect the battery wire directly to the car battery positive terminal (+) and the ground wire to the car body. There is the risk of a fuse burning out if only one of these is connected.

Grommet	Special red battery wire
	After making all other connections at the amplifier,
	connect the battery wire terminal of the amplifier to
	the positive (+) terminal of the battery.
Fuse (30 A) ⋅ 3	Ground wire (black)
[RD-223]	Connect to metal body or chassis.
		External Output
(sold separately)
[RD-222] (sold separately)
Bass Boost		Car stereo with
Remote Control	Bass Boost Remote	RCA output jacks
	Control Wire
	6 m
Jack for the bass boost
remote control		Connecting wire with RCA
Connect this jack and
		pin plugs (sold separately).
the bass boost remote
control with the bass
boost remote control
wire.		RCA input jack

Fuse (40 A)	Speaker output terminal	SYNC OUTPUT/SYNC INPUT jack
		See the “Connecting the Speaker Wires”
	See the “Connecting the

Speaker Wires” section for	section for SYNC OUTPUT/SYNC
	INPUT jack connection instructions.
speaker connection instruc-
tions.

System remote control wire (sold separately)

Connect the male terminal of this wire to the system remote control terminal of the car stereo (SYSTEM REMOTE CONTROL). The female terminal can be connected to the auto-antenna relay control terminal. If the car stereo does not have a system remote control terminal, connect the male terminal to the power terminal through the ignition switch.

ENGLISH ESPAÑOL DEUTSCH FRANÇAIS ITALIANO NEDERLANDS êìëëäàâ

6