Pioneer PRS-D1100M owner manual Connecting the Power Terminal, Connecting the Unit, RD-223, RD-222

Connecting the Unit

Connecting the Power Terminal

•Always use the special red battery and ground wire ([RD-223] and [RD-222]), which are sold separately. Connect the battery wire directly to the car battery positive terminal (+) and the ground wire to the car body. There is the risk of a fuse burning out if only one of these is connected.

1.Pass the battery wire from the engine compartment to the interior of the vehicle.

•After making all other connections to the amplifier, connect the battery wire terminal of the amplifier to the positive (+) terminal of the battery.

[RD-223]	Engine
	Fuse (30 A) compart-	Interior of
	ment	the vehicle

2.Twist the battery wire, ground wire and system remote control wire.

Twist

3.Attach lugs to wire ends. Lugs not supplied.

• Use pliers, etc., to crimp lugs to wires.

Lug

Ground wire

Lug

Battery wire

Fuse (30 A) Positive terminal

Insert the O-ring rubber grommet into the vehicle body.

[RD-222]	Engine
Fuse (30 A)	compart-
	ment

Drill a 14 mm hole into the vehicle body.

Interior of the vehicle

4.Connect the wires to the terminal.

•Fix the wires securely with the terminal screws.

	GND terminal
Power terminal	System remote
	control terminal
	System remote
	control wire

Positive terminal	Drill an 8 mm
Insert the O-ring rubber
	hole into the
grommet into the vehicle
	vehicle body.
body.

Ground wire

Battery wire

WARNING

Failure to securely fasten the battery wire to the ter- minal using the terminal screws could cause the ter- minal area to overheat and could result in damage and injury including minor burns.

7