Additional information
Problem | Remedy |
No sound is output when an | • If you’re using the line input, make sure the component is connected correctly and the |
input function is selected. | volume level of your external component (i.e. a portable player, etc.) is adjusted (see |
| Connecting auxiliary components on page 38). |
| • Turn up the volume. |
| • No audio is output from the speakers connected to this unit if HDMI Mode is set to |
| Through Mode (page 45). |
| • No audio is output if a DVI component is connected via HDMI. |
| • Press MUTE on the remote control to turn muting off. |
|
|
No sound from surround | • Refer to Channel level setting on page 35 to check the speaker levels. |
speaker. | • Check that you haven’t selected the Stereo mode (see Listening in surround sound on |
| page 29). |
| • Connect the speakers properly (refer to Connecting up on page 10). |
| • Verify the audio output and HDMI settings of your external component when connecting |
| an external component via an optical digital cable or HDMI cable. |
|
|
Can’t operate using the remote | • Replace the batteries (Putting the batteries in the remote control on page 25). |
control. | • Operate within 23 ft., 30° of the remote sensor (Using the remote control on page 26). |
| • Remove any obstacles or operate from another position. |
| • Avoid exposing the remote sensor on the front panel to direct light. |
| • For operating the other Pioneer component connected to the CONTROL OUT jack of this |
| receiver subwoofer, make sure that the control cable and either an HDMI or analog audio |
| cable are connected (page 44). |
|
|
Tuner
Problem | Remedy |
Considerable noise in radio | • Connect the AM antenna (refer to Connecting up on page 10) and adjust the direction |
broadcasts. | and position for best reception. You may also connect an additional internal or external AM |
| antenna (refer to Connecting external antennas on page 44). |
| • Fully extend the FM wire antenna, position for best reception, and secure to a wall. You |
| may also connect an outdoor FM antenna (see Connecting external antennas on page 44). |
| • Turn off other equipment that may be causing the noise or move it further away. |
| • The tuning interval is incorrect for your country or region. See Changing the frequency |
| step on page 34 to switch the tuning interval. |
|
|
Auto tuning does not pick up | • The radio signal is weak. Auto tuning will only detect radio stations with a good signal. |
some stations. | For more sensitive tuning, connect an outdoor antenna. |
|
|
HDMI
Symptom | Remedy |
No picture or sound. | • This receiver is |
| also |
| • Depending on the connected source component, it’s possible that it will not work with |
| this receiver (even if it is |
| • If the problem still persists when connecting your HDMI component directly to your |
| monitor, please consult the component or monitor manual or contact the manufacturer for |
| support. |
|
|
No sound, or sound suddenly | • Check that the HDMI Mode setting is set to AMP Mode/Through Mode. |
ceases. | • If the component is a DVI device, use a separate connection for the audio. |
| • Check the audio output settings of the source component. |
|
|
10
English
53
En