CHANNEL STEP SETTING (VSX-D908TX/D908TX-G only)
The unit has been factory preset to the channel allocation value for the area in which it is to be sold. If this value is set incorrectly, the tunes in frequency may be wrong, or sound may be distorted, resulting in an inability to reproduce reception signals at their proper sound quality. For this reason, be sure to confirm that the values are set correctly before first using the unit.
FM 100 kHz, AM 10 kHz:
Set to this position for areas with an FM reception step of 100 kHz and AM 10 kHz.
FM 50 kHz, AM 9 kHz:
Set to this position, for areas with an FM reception step of 50 kHz and AM 9 kHz.
NOTE:
When unsure about the channel allocation for your area, consult your dealer for correct information.
To Change Channel Steps
With the power turned OFF, hold the STANDBY/ON button depressed while pressing the FM/AM function button to turn the power ON.
∙Each time the above operation is performed, the channel tuning step will alternate between FM 100 kHz/AM 10 kHz, and FM 50 kHz/AM 9 kHz.
STANDBY/ON | FM/AM |
TWO VOLTAGE SELECTOR SWITCHES
Mains voltages in Saudi Arabia are 127 V and 220 V only. Never use this model with the 110 V setting in Saudi Arabia. The line voltage selector switches are on the rear panel. Check that they are set properly before plugging the power cord into the household wall socket. If the voltage is not properly set or if you move to an area where the voltage requirements differ, adjust the selector switches as follows.
1.Use a
2.First, insert the screwdriver in the groove of the voltage selector upper, and adjust so that the tip of the groove points to the voltage value of your area.
3.Next, insert the screwdriver in the groove of the voltage selector lower and adjust until the voltage is the same as at the right.
TWO VOLTAGE SELECTORS
220V240V
110V
110V |
|
|
| 220V |
|
|
| 240V | |
|
|
| ||
|
|
|
|
|
3