Pioneer VSX-D938TX, VSX-D908TX Surround Sound Set Up, To exit before outputting the TEST TONE

Surround Sound Set Up

ë￿

S0URCERECEIVER

MULTI SYSTEM

OPERATION OFF

DVD/LD TV/SAT VCR1 VCR2

	MULTI CONTROL
CD	MD/	TUNER	TV CONT
	TAPE1
CLASS	MPX	BAND	DIRECT ACCESS
¦￿	7	3	8
- TUNING +		- STATION +
1 Á￿		4 ¢
		- CHANNEL +
1	2		3
4	5		6
7	8		9
+10	0		DISC
RF ATT			DISPLAY
	TV
TV VOL	TV CONTROL		VOLUME

TV FUNC

3After selecting SETTING START with the button press ENTER. The TEST TONE will be output.

These settings will be displayed on your TV.

Channel Level
Test Tone				[ AUTO ]
[						]
	Setting OK
Front				[			]
					0dB
		L
Center				[ 0dB]
Front				[ 0dB]
		R
Surround				[ 0dB]
			R
Surround				[ 0dB]
			L
Subwoofer				[ 0dB]

EFFECT	MENU	MUTE
/CH SEL			SIGNAL	STEREO	VOLUME
			SELECT

	FUNCTION	ANALOG SP	A
3,4			dB
	SELECT	AUTO
	ENTER
	SIGNAL

		2/dts
SYSTEM	THX	ADVANCED	STANDARD
SETUP
			MPEG	It takes a moment for the machine to set itself. MASTER VOLUME
SETUP
REMOTE	MIDNIGHT	DSP	STEREO
			DIGITAL NR	rotates to the reference position (0 dB), and the test tone is output.
				To exit before outputting the TEST TONE
	REMOTE CONTROL UNIT			Press ENTER.
AV PREPROGRAMMED AND LEARNING

SET UP

VSX-D938TX

To exit while outputting the TEST TONE

Press ENTER.

It is possible to set channels levels independently for 2 Surround/dts, STEREO, EXTERNAL DECODER and each DSP mode for listening once purposes (see p.24 6).

This function is designed to be used when you want to change the levels temporarily to hear one speaker louder.

You sould return the settings to their original state when done.

4Adjust speaker levels so that you hear the test tone at the same volume from each speaker when seated in your main listening position.

NOTE : The volume of the sub woofer tends to sound lower than it actually is, you may need to raise its level after testing the sound with actual soundtracks.

In AUTO mode

1Press 2 or 3 to adjust the level of the speaker outputting the

TEST TONE.

In MANU mode

1Press 2 or 3 to adjust the level of the first speaker.

2Press 5´° to switch the TEST TONE to the next speaker.

3 Repeat 1 and 2 for each speaker.

If you are using a Sound Pressure Level (SPL) meter

Take the readings from your main listening position and adjust the level of each speaker to 75 dB SPL (C-weighted/slow model).

5When you have adjusted each speaker level, select SETTING OK and press ENTER to return to the previous screen.

The MASTER VOLUME will return to its original position. Next, proceed to CROSSOVER NETWORK below.

If you want to change a setting before proceeding.

Simply use the arrow buttons to go back.

6Select EXIT with the 5´° buttons and press ENTER to return to the SYSTEM SETUP MENU.

33