12Changing the settings
Software Update
Use this procedure to update the unit’s software. You can update the software via a USB storage device.
Updating via a USB storage device is performed by downloading the update file from a computer, reading this file onto a USB storage device then inserting the USB storage device into the USB port on the unit’s front panel.
•If an update file is provided on the Pioneer website, download it onto your computer. When downloading an update file from the Pioneer website onto your computer, the file will be in ZIP format. Unzip the ZIP file before saving it on the USB storage device. If there are any old downloaded files or downloaded files for other models on the USB storage device, delete them.
Important
•DO NOT unplug the power cord during updating.
•When updating via a USB storage device, do not disconnect the USB storage device.
1 Press SET UP.
The Initial Setup screen is displayed on the main display.
2Select Option Setting Software Update
Start, then press ENTER.
Sound settings
Using the Virtual Surround/Sound Retriever
You can add exciting effects to audio sources.
1Press SOUND to select Virtual Surround or Sound Retriever.
2Use / to select On or Off, then press
ENTER.
About Sound Retriever
This function enhances sound data lost during compression of MP3 and other file types, allowing the user to enjoy sound quality closer to that of the original signal data.
Adjusting the bass and treble
Use the bass and treble controls to adjust the overall tone.
1Press SOUND to select Bass or Treble.
2Use / to adjust the bass or treble, then press ENTER.
You can adjust low and high sounds on a scale of
Software Update
Start
Cancel
3 To update, select OK.
The updating screen appears and updating starts.
•The power turns off automatically once updating is completed.
Software Update messages
Status Description messages
File Not Found. No update file was found on the USB storage device. Store the file in the USB storage device’s root directory.
Data format Try disconnecting then reconnecting the
error.USB storage device or storing the update file again. If the error still occurs, try using a different USB storage device.
34Update failed. Contact the authorized service center.
Resetting the system
Use this procedure to reset all system settings to the factory default.
Important
•Disconnect all components connected to this unit before the operation.
1 Press STANDBY/ON.
The unit turns on.
2Press and hold and STANDBY/ON on the top panel for three seconds.
The unit turns off (standby mode).
All the settings will be reset to the factory default next time the unit is turned on.
En