Additional information

13

Wireless LAN

Problem

Check

Remedy

Network cannot be accessed

Is Network Type set to Auto and

Switch Network Type to Wireless or disconnect the LAN cable

via wireless LAN.

the LAN cable connected to the unit?

from the unit, then restart the unit.

 

 

If Network Type is set to Auto and the LAN cable is connected to

 

 

the unit, the unit recognizes the Network Type as Wired.

 

 

 

 

This unit and base unit (wireless LAN

Improve the wireless LAN environment by moving the unit and base

 

router, etc.) are too far apart or there

unit closer together, etc.

 

is an obstacle between them.

 

 

 

 

 

There is a microwave oven or other

Use the system in a place away from microwave ovens or others

 

device generating electromagnetic

device generating electromagnetic waves.

 

waves near the wireless LAN

 

 

Avoid using devices generating electromagnetic waves as much as

 

environment.

 

possible when using the system with the wireless LAN.

 

 

 

 

 

 

Multiple wireless devices are

When connecting multiple wireless devices, their IP addresses

 

connected to the wireless LAN

must be changed.

 

router.

 

 

 

 

 

Wireless LAN connections cannot be

The unit must be set in order to establish wireless LAN

 

established between the unit and

connections. See Connecting using wireless LAN on page 8.

 

base unit (wireless LAN router, etc.).

 

 

 

 

 

The IP address settings of the unit

Check the IP address settings of the unit (including the DHCP

 

does not match the settings of the

setting).

 

wireless LAN router, etc.

If the unit’s DHCP setting is on, turn the unit’s power off, then turn

 

 

the power back on.

 

 

Check that the IP addresses of the unit match the settings of the

 

 

wireless LAN router, etc.

 

 

If the unit’s DHCP setting is off, set an IP address matching the

 

 

network of the base unit (wireless LAN router, etc.).

 

 

For example, if the wireless LAN router’s IP address is

 

 

“192.168.1.1”, set the unit’s IP address to “192.168.1.XXX” (*1), the

 

 

subnet mask to “255.255.255.0”, the gateway and DNS to

 

 

“192.168.1.1”.

 

 

(*1) Set the “XXX” in “192.168.1.XXX” to a number between 2 and

 

 

248 that is not assigned to other devices.

 

 

 

 

The access point is set to conceal the

In this case, the SSID may not be displayed on the access point list

 

SSID.

screen. If not, set the SSID, etc., by making the wireless LAN

 

 

settings on the unit manually.

 

 

 

 

The access point’s security settings

The unit does not support WEP 152-bit length code key or shared

 

use WEP 152-bit length code key or

key authentication.

 

shared key authentication.

 

 

 

 

Español Français English

39

En