13Additional information
When a USB storage device is connected
Problem | Check | Remedy | |
USB storage device is not | Is the USB storage device properly | Connect the device securely (all the way in). | |
recognized. | connected? |
| |
|
|
| |
| Is the USB storage device connected | This unit does not support USB hubs. Connect the USB storage | |
| via a USB hub? | device directly. | |
|
|
| |
| This is not a problem with this unit. | Turn the power off then back on. | |
|
|
| |
|
| Some USB storage devices may not be recognized properly. | |
|
|
| |
|
| This unit only supports USB mass storage class devices. | |
|
|
| |
|
| Only the FAT16 and FAT32 file systems are supported. Other file | |
|
| systems (ex. FAT, NTFS, etc.) are not supported. | |
|
|
| |
|
| This device does not support the use of external hard disc drives. | |
|
|
| |
Folder or file names are not | This is not a problem with this unit. | The order of the folder and file names depends on the order in | |
displayed in alphabetical |
| which the folders or files were recorded on the USB storage device. | |
order. |
|
| |
|
|
| |
Much time is required to | What is the USB storage devices | Some time may be required to load the data when large capacity | |
recognize the USB storage | capacity? | USB storage devices are connected (this could take several | |
device. |
| minutes). | |
|
|
| |
Power is not supplied to the | Is error displayed on the front panel | Turn the power off then back on. | |
USB storage device. | display? No power is supplied if the |
| |
Turn the power off, then disconnect and reconnect the USB storage | |||
| power consumption is too high. | ||
| device. | ||
|
| ||
|
|
| |
|
| Press FUNCTION / to switch to the other mode, then switch | |
|
| again to the USB mode. (When the input is switched back to USB.) | |
|
|
|
Network
Problem | Check | Remedy |
Cannot access to the | The LAN cable is not firmly | Firmly connect the LAN cable (page 8). |
network. | connected. |
|
|
|
|
| The router is not switched on. | Switch on the router. |
|
|
|
Cannot access to the network | Network Type is set to Wired. | Network Type must be set to Wireless or Auto to use WPS |
using WPS. |
| connection. See page 32 to change the network |
|
| type. |
|
|
|
Cannot access to the | Internet security software is currently | There are cases where a component with Internet security software |
component or PC connected | installed in the connected | installed cannot be accessed. |
via network. | component. |
|
|
|
|
| The audio component on the network | Switch on the audio component on the network before switching on |
| which has been switched off is | this unit. |
| switched on. |
|
|
|
|
| The component connected to the | If the client is automatically authorized, you need to enter the |
| network is not properly set. | corresponding information again. Check whether the connection |
|
| status is set to “Do not authorize”. |
|
|
|
| There are no playable audio files on | Check the audio files stored on the component connected to the |
| the component connected to the | network. |
| network. |
|
|
|
|
Playback does not start. | The component is currently | Check whether the component is properly connected to this unit or |
| disconnected from this unit or the | the power supply. |
| power supply. |
|
|
|
|
36
En