22 Network connection

Remote network control

Once the display is connected via LAN connection, you can access the display’s built-in remote network control interface using a computer and the display’s IP address.

Notes:

The computer and display must have the same Subnet Mask, Default Gateway, Primary DNS and Secondary DNS settings.

You cannot control the display via the RS-232C connection when LAN control is in use. However, you can set the TCP port number of the LAN connection to 4660 if you want to control the display using RS-232 protocol. See "RS232 commands over the network" on page 30.

The recommended Internet browser is Internet Explorer version 7.0 or higher.

1.Enter the IP address of the display in the address bar of the Internet browser and press Enter.

2.The remote network control interface appears.

Information

The Information page provides general information about the display.

Page 24
Image 24
Planar PS4652/PS5552/PS6552 manual Remote network control, Information