Planar PS4652/PS5552/PS6552 manual RS232 commands over the network

30 Network connection

RS232 commands over the network

The PS-Series also supports extending access to the RS232 commands over a network connection. Below are the steps to follow for controlling the display over LAN through the RJ45 connector.

1.Connect display & PC to hub or connect display to PC with LAN cable directly.

2.Set display IP address. (See "Connecting the display to a local area network" on page 21)

3.Commands are sent via TCP connection to port 4660. The commands are the same as for the RS232 port (see PS-Series RS232 manual on www.planar.com).

4.You can test commands using any TCP utility program that allows you to enter binary data in hexadecimal format. (Note: Contact Planar Technical Support for recommended programs.)