Appendix B - About Wireless LANs
Channels
The Wireless Channel sets the radio frequency used for communication.
∙Access Points use a fixed Channel. You can select the Channel used. This allows you to choose a Channel which provides the least interference and best perform- ance. In the USA and Canada, 11 channel are available. If using multiple Access Points, it is better if adjacent Access Points use different Channels to reduce inter- ference.
∙In "Infrastructure" mode, Wireless Stations normally scan all Channels, looking for an Access Point. If more than one Access Point can be used, the one with the strongest signal is used. (This can only happen within an ESS.)
∙If using
WEP
WEP (Wired Equivalent Privacy) is a standard for encrypting data before it is transmit- ted.
This is desirable because it is impossible to prevent snoopers from receiving any data which is transmitted by your Wireless Stations. But if the data is encrypted, then it is meaningless unless the receiver can decrypt it.
If WEP is used, the Wireless Stations and the Access Point must have the same settings for each of the following:
WEP | Off, 64 Bit, 128 Bit |
|
|
Key | For 64 Bit encryption, the Key value must match. |
| For 128 Bit encryption, the Key value must match |
WEP Authentication | Open System or Shared Key. |
|
|
If all your Wireless stations support
If
WPA PSK | Enter the same value on every station and the AP. The |
PSK must be from 8 to 63 characters in length. The | |
| 256Bit key used for the actual encryption is derived |
| from this key. |
Encryption | The same encryption method must be used. The most |
| common encryption method is TKIP. Another widely- |
| supported method is AES. |
|
|
115