Installation

2. Connect LAN Cables

Use standard LAN cables to connect PCs to the Switching Hub ports on the ADE- 4300/ADW-4300. Both 10BaseT and 100BaseT connections can be used simulta- neously.

If required, connect any port to a normal port on another Hub, using a standard LAN cable. Any LAN port on the ADE-4300/ADW-4300 will automatically function as an "Uplink" port when required.

3. Connect ADSL Cable

Connect the supplied ADSL cable from to the WAN port on the ADE-4300/ADW- 4300 (the RJ11 connector) to the ADSL terminator provided by your phone com- pany.

4. Power Up

Connect the supplied power adapter to the ADE-4300/ADW-4300. Use only the power adapter provided. Using a different one may cause hardware damage. Power it up by pressing the rear-mounted power switch.

5. Check the LEDs

∙The Power LED should be ON.

∙The Status LED should flash, then turn Off. If it stays on or blinking after 60 sec- onds, there is a hardware error.

∙For each LAN (PC) connection, one of the LAN LEDs should be ON (provided the PC is also ON.)

∙The WLAN LED should be ON. (ADW-4300 only)

∙The WAN LED should be ON if ADSL line is connected.

∙The Internet LED may be OFF. After configuration, it should come ON.

For more information, refer to Front-mounted LEDs in Chapter 1.

9