Content Security Gateway User’s Manual

How to use Address Table

With easily recognized names of IP addresses and names of address groups shown in the address table, the Administrator can use these names as the source address or destination address of control policies. The address table should be built before creating control policies, so that the Administrator can pick the names of correct IP addresses from the address table when setting up control policies.

4.3.1.1 LAN

Entering the LAN window

Step 1. Click LAN under the Address menu to enter the LAN window. The current setting information such as the name of the LAN network, IP and Netmask addresses will show on the screen.

ÍÍ

Definition

Name: Name of LAN network address.

IP / Netmask: IP address and subnet mask of LAN network

MAC Address: MAC address corresponded with LAN IP address.

Configure: You can configure the settings in LAN network. Click Modify to change the parameters in LAN network. Click Remove to delete the settings.

In the LAN window, if one of the members has been added to Policy or LAN Group, the Configure column will show the message – In Use. In this case, you are not allowed to modify or remove the setting.

Adding a new LAN Address

Step 1. In the LAN window, click the New Entry button.

Step 2. In the Add New Address window, enter the settings of a new LAN network address.

Step 3. Click OK to add the specified LAN network or click Cancel to cancel the changes.

- 44 -