2. Connect LAN Cable

Use the supplied LAN cable to connect the LAN port on the IAD-200 / IAD-200W to your hub.

3. Connect ADSL Cable

Connect the supplied ADSL cable from the ADSL port on the IAD-200 / IAD-200W to the ADSL terminator provided by your phone company.

4. Connect PSTN Line

Connect the PSTN socket on the rear of the IAD-200 / IAD-200W to your normal phone line socket.

5. Connect Phone

Connect a standard phone to the Phone socket on the rear of the IAD-200 / IAD-200W.

6. Power Up

Connect the supplied power adapter to the IAD-200 / IAD-200W. Use only the power adapter provided. Using a different one may cause hardware damage.

Power up by pressing the rear-mounted power switch IN, and wait for startup to be com- pleted.

7.Check the LEDs

•The Power LED should be ON.

•The Status LED should flash, then turn Off. If it stays on, there is a hardware error.

•Either the 100BT or 10BT LED should be ON.

•Phone LED should be OFF.

•PSTN LED will be OFF.

•WLAN LED should be ON (IAD-200W only).

•ADSL LED should be ON.

•Internet LED will be OFF.

It will come ON when configuration is complete and correct, and an Internet connec- tion is established.

For more information, refer to Front-mounted LEDs in Chapter 1.

9