Wireless Station Configuration (IAD-200W only)

This section applies to all Wireless stations wishing to use the IAD-200W's Access Point, regardless of the operating system which is used on the client.

To use the Wireless Access Point in the IAD-200W, each Wireless Station must have compatible settings, as follows:

Mode

The mode must be set to Infrastructure (rather than Ad-hoc)

 

Access points only operate in Infrastructure mode.

 

 

SSID (ESSID)

This must match the value used on the IAD-200W. The default value is

 

Wireless.

 

Note! The SSID is case sensitive.

 

 

Wireless

By default, Wireless security on the IAD-200W is disabled.

Security

• If Wireless security remains disabled on the IAD-200W, all stations

 

must have wireless security disabled.

 

• If Wireless security is enabled on the Wireless VoIP Gateway

 

(either WEP or WPA-PSK), each station must use the same settings

 

as the Wireless ADLS VoIP Gateway.

 

 

Wireless Configuration on Windows XP (IAD-200W only)

If using Windows XP to configure the Wireless interface on your PC, the configuration procedure is as follows:

1.Open the Network Connections folder. (Start - Settings - Network Connections).

Figure 25: Network Connections (Windows XP)

2.Right-click the Wireless Network Connection, check that it is enabled (menu option says Disable, rather than Enable) and then select View Available Wireless Networks.

3.You will then see a list of wireless networks.

37