If you cannot connect

If the IAD-200 / IAD-200W does not respond, check the following:

•The IAD-200 / IAD-200W is properly installed, LAN connection is OK, and it is powered ON. You can test the connection by using the "Ping" command:

•Open the MS-DOS window or command prompt window.

•Enter the command:

ping 192.168.0.1

If no response is received, either the connection is not working, or your PC's IP address is not compatible with the IAD-200 / IAD-200W's IP Ad- dress. (See next item.)

•If your PC is using a fixed IP Address, its IP Address must be within the range 192.168.0.2 to 192.168.0.254 to be compatible with the IAD-200 / IAD- 200W's default IP Address of 192.168.0.1. Also, the Network Mask must be set to 255.255.255.0. See Chapter 4 - PC Configuration for details on checking your PC's TCP/IP settings.

•Ensure that your PC and the IAD-200 / IAD-200W are on the same network segment. (If you don't have a router, this must be the case.)

•Ensure you are using the wired LAN interface. The Wireless interface can only be used if its configuration matches your PC's wireless settings.

Setup Wizard

The first time you connect to the IAD-200 / IAD-200W, you should run the Setup Wizard to configure the IAD-200 / IAD-200W for Internet access.

1.Select Setup Wizard on the main menu.

2.Step through the Wizard until finished.

•You need the data supplied by your ISP. Most connection methods require some data input.

•The common connection types are explained in the following table.

3.On the final screen of the Wizard, run the test and check that an Internet connection can be established.

4.If the connection test fails:

•Check all connections, and the front panel LEDs.

•Check that you have entered all data correctly.

12