Å EFFECT MIX Controls, Ÿ H.P CUE Headphones cue switch

PART NAMES AND FUNCTIONS

≠Effect beat selector switches (@, #)

Use this switch to change the value of Effect PARAMETER 1 control (‹) in accordance with the BPM of the source selected with the Effect CH. SELECT switch (¤). The setting value of this switch differs depending on the setting of the Effect selector switch (⁄).

¶When DELAY, ECHO, PAN, or TRANS are selected, the parameter 1 value for the BPM of the selected source can be set to 1/4 beat, 1/2 beat, 1/1 beat, 2/1 beat, 4/1 beat, or 8/1 beat.

¶When DELAY or ECHO are selected, values can be set to 1/4x, 1/2x, 1/1x, 2/1x, 4/1x or 8/1x, within a range such that the parameter 1 value does not exceed 3500 ms.

¶When FILTER or FLANGER are selected, the parameter 1 value for the BPM of the selected source can be set to 1/2 beat, 1 beat, 2 beats, 4 beats, 8 beats, 16 beats, or 32 beats.

¶When PITCH is selected, the value can be set to –100%, –50%, –33%, 0%, 33%, 50%, or 100%.

¶When REVERB is selected, the value can be set to 10%, 20%, 35%, 50%, 65%, 80%, or 90%.

¶This control is disabled when AUTO BPM or SND/RTN are selected.

ŸH.P CUE (Headphones cue switch)

When this switch is pressed it lights orange, and beat effects are output to the headphones. Pressing the switch again disconnects the beat effect to the headphones and turns off the switch lamp.

⁄Effect selector switch

Use to select desired effects (see page 12).

¤CH. SELECT (Effect channel selector switch)

Use to select the source you wish to apply effects to.

‹TIME (PARAMETER 1) (Effect parameter 1 control)

This control is used to set the time parameter for the

onboard effector (see page 14).

›LEVEL/DEPTH (PARAMETER 2) (Effect parameter 2 control)

This control is used to set quantitative parameters for the onboard effector (see page 14).

ﬁON/OFF, TAP (Effect ON/OFF switch, TAP switch) This switch produces different operations depending on the setting of the Effect selector switch (⁄)

¶When DELAY, ECHO, PAN, TRANS, FILTER, FLANGER, REVERB, PITCH, or SND/RTN are selected, the switch operates to turn the selected effect ON/OFF.

OFF: the orange lamp lights; ON: orange lamp flashes.

¶When AUTO BPM is selected the switch becomes a “TAP” switch; by tapping the switch together with the source beat, the BPM can be input manually.

When tapping the TAP switch to count the BPM, both BPM counter range displays (70-139 BPM and 91-180 BPM) go out, and the manual mode is enabled (see page 19).