Plantronics DJM-3000 Set the parameter value, Turn on the Effect ON/OFF switch

USING THE EFFECT FUNCTIONS

1Set the Effect selector switch to DELAY.

2Set the Effect CH. SELECT switch to 2.

÷The Effect parameter/BPM display LED “2” will light.

÷The BPM of the music input to CH-2 will be displayed on the AUTO BPM COUNTER.

*The BPM band that matches the music on CH-2 can be selected with the BPM counter range selector switch.

*The counter will flash if BPM cannot be counted for more than 2 seconds. In this case, use manual mode to make settings (see page 19).

Precautions:

÷If the channel has been changed with the Effect CH. SELECT switch when delay, echo, reverb (pages 16 and

17)and similar effects have been turned on, all of the reverberation of the prior channel’s effects will be output.

÷Only operate the Effect selector switch when effects are off (when the Effect ON/OFF switch is lit orange). Operating it with effects on could generate noise.

÷Display where a 1/2-beat delay (250mSec) has been set to music with a BPM of 120 (time conversion: 500mSec).

3Set the parameter value.

When the H.P CUE switch (in the BEAT EFFECTS controls) is pressed, the effect can be confirmed by listening to the headphones output.

Setting the Delay Time

÷Setting the delay time to match one beat of the BPM displayed on the AUTO BPM COUNTER makes effect application more effective.

÷By pressing the Effect beat selector switch (@ or #), delay time of 1/4 to 8/1 can be set for one beat of the counted BPM.

÷More precise delay times can be set with the Effect PARAMETER 1 control (TIME).

÷As “1/2” will light on the beat display if delay time is set to 1/2 of one beat of the BPM, the parameter value can

be set using the beat display as a guide.

Setting to Balance Original and Delayed Sound Levels

÷The balance between original and delayed sound levels is set using the Effect PARAMETER 2 control (LEVEL/ DEPTH). Turning this control to the left will decrease delayed sound and turning it to the right will increase it.

4Turn on the Effect ON/OFF switch.

÷The Effect ON/OFF switch will flash orange, and the delay effect will be applied to master output.

÷If the switch is pressed once more, the effect will be

turned off.

*If it is turned on in time to the beat, the effect’s cycle will also start on the beat.

Echo, auto pan, auto trans, filter, flanger can also be set similarly.

BPM display
	Counter
	BPM counter range
	selector switch
Effect parameter/
BPM display	LED
	Counter
	Beat display
“1/2” will light	Effect beat selector
	switches

15

<DRB1314>