CAUTIONS REGARDING HANDLING
Location
Install the unit in a
÷Do not install the unit in a location which is exposed to direct rays of the sun, or near stoves or radiators. Excessive heat can adversely affect the cabinet and internal components. Installation of the unit in a damp or dusty environment may also result in a malfunction or accident. (Avoid installation near cookers etc., where the unit may be exposed to oily smoke, steam or heat.)
÷When the unit is used inside a carrying case or DJ booth, separate it from the walls or other equipment to improve heat radiation.
Installing the DJM-3000 in an EIA rack
The screw holes on the front panel of the
÷Attach the unit to the rack using screws of the appropriate size (screws not provided with the unit).
Note
÷Never place this unit directly above a power amplifier, as the heat given off by the amplifier might result in damage to the unit. Placing the unit directly above a power amplifier might also result in ham radio signals being picked up or in other types of interference.
÷Always be sure to remove the unit from its rack before shipping.
÷When moving the unit while still installed in its rack, exercise caution to avoid subjecting the unit to shocks or vibration.
Condensation
When this unit is brought into a warm room from previously cold surroundings or when the room temperature rises sharply, condensation may form inside, and the unit may not be able to attain its full performance. In cases like this, allow the unit to stand for about an hour or raise the room temperature gradually.
Cleaning the Unit
÷Use a polishing cloth to wipe off dust and dirt.
÷When the surfaces are very dirty, wipe with a soft cloth dipped in some neutral cleanser diluted five or six times with water and wrung out well, then wipe again with a dry cloth. Do not use furniture wax or cleaners.
÷Never use thinners, benzene, insecticide sprays or other chemicals on or near this unit, since these will corrode the surfaces.
5
