Polycom 4400 AP Configuration

Configuration Guide

AP Configuration

1. Power-on and connect the APs to the network. Wait a few minutes

for the APs to find the controller.

2. Verify the APs are associated to the WLC.

3. From the main menu, click Monitor.

1. From the main menu, click Wireless.

2. In the navigation pane, under Access Points select Radios, then

select 802.11b/g/n. All the APs that are connected should be

listed, showing their Operational Status as UP.

3. Select Configure from the drop-down list for the access point you

wish to change.

Global settings for RF Channel Assignment and Tx Power Level

Assignment were not tested during VIEW Certification. For Custom

Tx Power and RF Channel settings please consult your facility’s RF

site survey — optimized for wireless voice traffic — to determine

correct power and channel settings for each AP using only channels

1, 6 and 11.

PN: 1725-36070-001_P.doc