Polycom 4400 - page 22

Configuration Guide

8. Under the Security tab, select the desired security policy (either

WPA or WPA2) and enter all required options.

9. Under the QoS tab, set Quality of Service to Platinum (voice).

(Note: This is the required setting for voice traffic.)

10. Set WMM Policy to Disabled. (Note: This is required for usage with

SpectraLink Wireless Telephones.)

11. Click the Apply button to save all changes.

WEP was not tested during VIEW Certification. WEP is supported

by both the LWAPPs and the SpectraLink Wireless Telephones.

PN: 1725-36070-001_P.doc

Contents

Main VIEW Certified Configuration Guide Cisco Trademark Information Patent Information Copyright Notice Notice Contact Information Introduction Certified Product Summary Known Limitations Access Point Capacity and Positioning Network Topology Configuring a New Controller Starting from Factory Defaults Connecting to the Controller via a Browser Installing Software Controller Setup Connecting APs Page AP Configuration Configuration for SpectraLink Wireless Telephones running in 802.11b mode Page Page Page Configuration for SpectraLink Wireless Telephones running in 802.11a mode Page Page Page Setting Up the SSIDs Setting up the voice SSID Page Page Further Assistance