Polycom DOC2559A manual Replacing the RTM-IP

Chapter 2- Component Replacement

Replacing the RTM-IP 4000

RTM-IP 4000 connections require Ferrite cables when connecting to MPMx cards.

The RTM-IP 4000 card on the rear of the RMX 4000 provides connectivity to all the MCU modules. Use the following procedure to replace the RTM-IP 4000 card:

1Ensure that the power switch/circuit switch on the RMX 4000 is turned OFF (O).

2Remove the cables connected to the card.

3Unscrew the captive screws on the rear panel of the RMX 4000 that secure the RTM-IP 4000 card.

4Use the metal ejector levers to pull the RTM-IP 4000 card out of its slot in the backplane.

5Carefully slide the RTM-IP 4000 card out through the rear panel.

6On the card to be installed, move the ejector levers to their fully open position.

7Slide in the replacement RTM-IP 4000 card.

8Push the RTM-IP 4000 card firmly into the backplane, making sure it is properly seated in its slots.

9Ensure that the metal ejector levers are fully retracted into their housings.

2-16