Polycom C16, SR12, C12, C8 manual Plug-in Card Installation

Hardware Installation Guide for the Polycom SoundStructure C16, C12, C8, And SR12

•Connect AC power. (See page 2-19.)

•Configure devices using SoundStructure Studio software. (See page 2-20.)

Plug-in Card Installation

Each SoundStructure device can have a plug-in card installed for a total of eight plug-in cards in a collection of eight SoundStructure devices. When installing more than one plug-in card in an installation, it is recommended to use the plug-in slot from the top device first and continue sequentially down through the collection of devices as additional plug-cards are added.

Warning Do not insert a plug-in card while the SoundStructure is powered on.

Failure to remove power prior to installing the plug-in card may damage the plug-in card and/or the SoundStructure device.

To install a plug-in card, follow these five steps:

1.If plugged in, unplug the AC power cord from the SoundStructure device.

PIN 2: TXD

PIN 3: RXD

PIN 5: GROUND

PIN 7: CTS

PIN 8: RTS

RS-232

LAN C-LINK2 IN OBAM OUT IR 12V

2.Remove the blank plate and screws from the expansion slot (see below).

PIN 2: TXD

PIN 3: RXD

PIN 5: GROUND

PIN 7: CTS

PIN 8: RTS

RS-232

LAN C-LINK2 IN OBAM IR 12V

2 - 4