11. Check Software Version
To check the released version of the M15S Controller program:
Step 1: Press 
Display
In the real value window, you will see the released version.
Step 2: Press | to confirm or press | to clear. |
12. Load Datum Values
The real value refers to the distance between the machine table and the cutterhead. Thus, the cutterhead defines the zero point of the machine. It is, however, difficult or impossible to move the planer table to this point. Therefore, the zero point should be identified by either placing a gauge between table and cutterhead knife insert, or by planing a test board then measuring the board thickness with calipers. Program this real value into the Controller as follows.
Preset the real value:
Step 1: 
Step 2: Enter the value.
Step 3: Press
30
