C O M M E R C I A L P R O D U C T S D I V I S I O N
Diagram 4 Front base assembly. |
|
Plastic grommet |
|
Front base tube |
|
Height adjustor |
|
| 1 |
Tighten the height |
|
adjustor so that the |
|
nut is secure against |
|
the front tube. |
|
Cut the tie wrap that | 2 |
secures the grommet | |
to the cable. |
|
3 |
4.Cut the tie wrap securing the front base tube to the pallet. Discard the tie wrap.
5.Thread the height adjustor to its lowest position. Diagram 4, #1 and #2. Remove the height adjustor from the Hardware kit. Ask an assistant to lift the front base tube while you insert the height adjustor.Turn the height adjustor so that the threads appear inside the base tube.Tighten the nut (with a crescent wrench) when the height adjustor is fully threaded into the front base tube.
6.Cut the tie wrap holding the plastic grommet. Diagram 4, #3. Use a wire cutter (or scissors) to remove the plastic grommet from the cable.
Diagram 5 Front base assembly.
Plastic grommet
Cable receptacle
Front base assembly
7.Insert the plastic grommet. Diagram 5. Place the grommet into the hole on the front base assembly. Press down so that it snaps into place.
page 12
