Assembling the Exercise Bike | 25 |
5.Adjust the position of the seat back, then tighten the screws completely using a 6 mm hex wrench.
6.Connect the heart rate sensor cable in the handlebars to the cable you passed through the seat back support earlier, then position the handlebars in the handlebar bracket as shown in the following figure. Feed any extra cable back into the seat back support.
Figure 9: Positioning the handlebars
Important: In the following step, be extremely careful not to trap or pinch the cable. Move the cable out of the way of the screws if necessary.
7.Secure the handlebars in place using two M10 x 55 mm buttonhead cap screws and two M10 hex nuts, as shown in the following figure. Tighten the fasteners completely using a 6 mm hex wrench and a 14 mm
