11.At the same time, insert a Pedal Arm Axle (21) into the Right Upper Body Leg (124) and into the right Pedal Arm (14); make sure that the
Upper Body Leg Spacer (113) and the Pedal Leg Spacer (114) are in the indicated loca- tions.
Attach the Right Upper Body Leg (124) with an M6 x 16mm Button Screw (80) and an M6 Washer (118).
Then, attach the right Pedal Arm (14) with an M6 x 16mm Button Screw (80) and an M6 Washer (118).
Repeat this step for the other side of the elliptical exerciser.
See step 3. Tighten the four M10 x 20mm Button Screws (79). Tip: Tighten the two
Button Screws on the front of the elliptical exerciser before tightening the other two Button Screws.
12.Identify the Right Upper Body Arm (9), which is marked with an “R” sticker. Orient the Right Upper Body Arm as shown; make sure that the hexagonal holes in the Right Upper Body Arm are in the indicated location.
Slide the Right Upper Body Arm (9) onto the Right Upper Body Leg (124). Attach the Right Upper Body Arm with two M6 x 38mm Button Bolts (76) and two M6 Nylon Locknuts (77); make sure that the Nylon Locknuts are inside the hexagonal holes.
Repeat this step for the Left Upper Body Arm (8) and the Left Upper Body Leg (6).
11 |
|
|
|
| 124 |
|
| 118 |
| 80 |
|
|
| 113 |
80 | 14 |
|
|
| |
118 |
|
|
|
| 21 |
|
| 114 |
12 |
|
|
8 |
| 9 |
|
| |
|
| 77 |
| 76 | Hexagonal |
|
| |
6 |
| Holes |
|
| 124 |
13.Make sure that all parts of the elliptical exerciser are properly tightened. Note: Some hardware may be left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the elliptical exerciser.
11
